Adafruit

MiFare Classic (13.56MHz RFID/NFC) White Tag - 1KB

SKU: 360
3.90 €
Stock status: 7
Delivery: 1-3 Days
This is a blank MiFare Classic 'laundry' tag - often used for laundry or identification but also found in other systems where a small proximity card is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the...
  • Tip
    Tell a friend
  • WISH
Share:

This is a blank MiFare Classic 'laundry' tag - often used for laundry or identification but also found in other systems where a small proximity card is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away

These can be read by almost any 13.56MHz RFID/NFC reader but make sure it can handle MiFare cards as there are a few other encoding standards (like FeLica) They are tested and work great with both our PN532 NFC/RFID breakout board and Adafruit NFC/RFID Shield for Arduino!

These chips can be written to & store up to 1 KB of data in writable EEPROM divided into banks, and can handle over 100,000 re-writes. You can use our PN532 NFC/RFID breakout board or Adafruit NFC/RFID Shield for Arduino to read and write data to the EEPROM inside the tag. There is also a permanent 4-byte ID burned into the chip that you can use to identify one tag from another - the ID number cannot be changed.

  • S50 chip specification:


    • 1 KiloByte (8 KiloBit) non-volatile EEPROM storage
    • Built in encryption engine with 48-bit key
    • 4 Byte unique identifier burned into the chip
    • 13.56 MHz frequency

  • Tag specification:


    • 25.4mm diameter x 1mm / 1" diameter x 0.03"

    • 0.9 grams / 0.03 oz
    • Works about 4" away from reader

  • Downloads: