m punkt nu

Voltage Injector 5v [Version 2.1 - RJ12]

SKU: injekt5v21
16.90 €
Stock status: 1
Delivery: 1-3 Days
With the voltage injector, you power up your 1wire network to run more power-consuming things like LED detectors or LCD displays.
NOTE! The voltage injector is usually not needed if you are using the USB adapter DS9490R - the voltage ...
  • Tip
    Tell a friend
  • WISH
Share:
With the voltage injector, you power up your 1wire network to run more power-consuming things like LED detectors or LCD displays.
NOTE! The voltage injector is usually not needed if you are using the USB adapter DS9490R - the voltage is automatically downloaded via the USB port!
Facts:
  • Has a protective diode to reduce the risk of damage in case the input voltage is wrong.
  • Any previous voltage supply in the 1wire network will end in the injector and a new voltage segment will begin.
  • The device has 2 rj12 connectors for connection to the 1 wire network, 1 input and 1 output.
  • Connect the voltage injector to a transformer / power supply that supplies stabilized DC voltage, + 5v or 7-12V must be connected. (9V recommended). The voltage used should be adjusted with a jumper on the circuit board. (+ 5V or 7-12V).
  • If you plan a current output being larger than about 100mA continuously, a 5V transformer should be used.
  • Output voltage when using 7-12V transformer: 5.0V. Output voltage when using 5V transformer: approx. 4.7V.
  • When the voltage injector is active, a red LED will light up and it is located between the RJ12 connectors.
  • When delivered, the voltage injector is set to operate with 7-12v.
  • If you open the voltage injector, make sure that you turn the cover correctly when you re-screw it.
  • The voltage from the battery simulator is passed on pin 5 in the rj12 output.